Functions | N2 | N3 |
Remote control of opening elements | X | |
Locking doors in motion and unlocking in an accident | X | |
Interior lighting control | X | |
Remote control audio system | X | |
Anti-theft control | X | |
Turn signal and emergency stop control | X | X |
Windshield and Rear Wiper Control | X | X |
Immobilizer control | X | X |
Warning sound control | X | X |
Rear window heating control | X | X |
Speed limit control | X | X |
Connecting the diagnostic tester | X | X |
Removing
Note. Before removing the control unit, we advise you to write down the configuration of the unit. If you install a unit with a different configuration, the diagnostic tester may interpret it as faulty.
1. Remove the fuse box cover.
2. Remove two screws (A) fuse block mounting.
3. Remove the bolt (IN) securing the control unit, pull the control unit up until it releases from the latch.
4. Disconnect wiring connectors.
5. Remove the control box from the protective housing.
Installation
Installation is carried out in the reverse order. Check the configuration of the unit, if necessary, program the ignition keys.
Connectors for the immobilizer control unit.
40-pin connector (A)
Terminal | Description |
1 | Not used |
2 | Not used |
3 | Not used |
4 | Not used |
5 | Not used |
6 | Vehicle speed sensor (entrance) |
7 | Windscreen and rear window cleaners (entrance) |
8 | Central locking, door opening (entrance) |
9 | Not used |
10 | Not used |
11 | Not used |
12 | Not used |
13 | Not used |
14 | Not used |
15 | Dimensions (entrance) |
16 | immobilizer antenna |
17 | Central locking, door closing (entrance) |
18 | Rear wiper stop position |
19 | Rear window cleaner (entrance) |
20 | Not used |
21 | Not used |
22 | Nutrition (after turning on the ignition) |
23 | Collision sensor (entrance) |
24 | Windshield Wiper Timer |
25 | Not used |
26 | Left turn indicator (entrance) |
27 | Not used |
28 | Right turn indicator (entrance) |
29 | Rear window washer (entrance) |
30 | Rear Passenger Door, Trunk Lid, Hood, Tailgate |
31 | Rear window heater control (exit) |
32 | immobilizer indicator (exit) |
33 | Emergency stop signal (entrance) |
34 | Diagnostic line K |
35 | Anti-theft relay (exit) |
36 | The engine control unit |
37 | Not used |
38 | Motor shaft speed (entrance) |
39 | Rear window heater (entrance) |
40 | driver's door |
15 pin connector (IN)
Terminal | Description |
A1 | "Earth" |
A2 | Local lighting (exit) |
A3 | Nutrition (permanent) |
A4 | Windscreen wiper control |
A5 | Windshield Wiper Power |
A6 | Windscreen wiper stop position |
A7 | Rear window cleaner (exit) |
A8 | Right turn indicator (exit) |
A9 | Left turn indicator (exit) |
IN 1 | Opening doors (exit) |
AT 2 | Closing the doors (exit) |
AT 3 | Power supply of the central locking system |
AT 4 | driver's door (exit) |
AT 5 | Interior lighting timer |
AT 6 | Interior lighting supply |