Removing
1. Remove the panel (1) and a plug (A).
2. Remove three bolts (IN) mirror mounts.
3. If necessary, disconnect the wiring connector.
4. Raise the mirror up (arrow 1) and to the side (arrow 2). remove the mirror.
Mirror glass replacement
1. Using a suitable lever, release the mirror glass from the clips.
2. If necessary, disconnect the glass heater connector.
3. At installation check up reliability of fixing of glass in a clip.
Cover replacement
1. Remove the mirror glass.
2. Using a screwdriver, release the glass base from the clips (A) covers, remove the cover.
3. To access the temperature sensor (IN) remove the plastic housing of the mirror base.
Electrical mirror connectors
Removing
Note. It is not necessary to remove the door panel to remove the mirror.
- The tightening torque of the mounting bolts is 2 Nm.
Examination
Terminal | Description |
1 | "Earth" mirror heater |
2 | Not used |
3 | "Earth" outside air temperature sensor (passenger side) |
4 | Outside air temperature sensor signal (passenger side) |
5 | Not used |
6 | Up down |
7 | Left/Right |
8 | electric motor |
9 | Not used |
10 | Mirror heater control |
Mirror control switch
Terminal | Description |
A1 | Left/Right (left door) |
A2 | "Earth" |
A3 | Up down (left door) |
IN 1 | Left/Right (right door) |
AT 2 | Up down (right door) |
VZ | Nutrition |
AT 4 | General control of both mirrors |
Left door mirror
Function | terminal | |
Up | AZ/VZ B4/A2 | |
Down | AZ/A2 B4/VZ | |
Left | B4/A2 A1/B3 | |
right | В4/ВЗ А1/А2 |
Right door mirror
Function | terminal | |
Up | B2/B3 B4/A2 | |
Down | B2/A2 B4/B3 | |
Left | B1/B3 B4/A2 | |
right | В4/ВЗ В1/А2 |