Contents: Removal 🠛 Installation 🠛
Figure 9.24. Hood details: 1 – loops; 2 – bolt; 3 – emphasis; 4 – lock drive lever; 5 – cable; 6 – lock; 7 – safety device; 8 – hood
The hood details are shown in Figure 9.24.
Removal
- be sure to mark the position of the hood hinges with a felt-tip pen;
- disconnect the fluid supply pipe to the washer nozzle, secured to the hood;
Figure 9.25. Hood mounting bolts
- unscrew the bolts securing the hood to the hinges (Figure 9.25), then, together with an assistant, carefully remove the hood from the car.
Installation
- screw in the hood mounting bolts, installing the hinges according to the previously applied marks, then tighten them securely;
- gently lower the hood and check that the latch engages in the lock. With the hood closed, make sure that the gaps between it and the fenders are equal on both sides and that the front edge of the hood is at the same height as the fenders;
- the adjustment of the hood side clearances is carried out by moving the hinges, if you loosen the bolts that attach them to the hood. The height of the front edge of the hood is adjusted by moving the hood lock. The clearance values are given at the beginning of the section.
(Information is located on the website RENAULTBOOK.ru)