Attention! The mirror glass can be replaced without removing the mirror itself.
Removing
1. Tilt the mirror housing forward.
2. Insert a suitable spatula or wedge between the glass and the mirror housing, eg FACOM Car. 1363 and carefully pry out the glass in the direction of the arrow (see illustration).
25.2 Insert a suitable spatula or wedge between the glass and the mirror body, eg FACOM Car. 1363 and carefully pry out the glass in the direction of the arrow
Attention! If a tool with sharp edges is used for these purposes, then paste over the mirror body with tape or put a rag so as not to scratch the body.
3. Disconnect the glass defroster wire (if available) (see illustration).
25.3 Disconnect the heater wire
Installation
4. Install the mirror glass 'by sliding it into the four guides A on the body (see illustration).
25.4 Install the mirror glass by inserting it into the four guides A on the body
5. Press down on the glass until it locks into the holders. Fixation will be clearly audible (see illustration).
25.5 Press down on the glass until it locks into the holders
Attention! This operation is recommended to be carried out with protective gloves to avoid injury from cracked glass.
6. Return the mirror housing to its original position.
Mirror body
Removing
7. Remove glass of a mirror.
8. Remove the four clips A and disconnect the mirror housing (see illustration).
25.8 Remove the four clips A and disconnect the mirror housing
Installation
9. Reinstall the mirror housing and secure with clips A (see illustration 25.8).
10. Install the mirror glass.