Removing
1. Turn the bar by hand in the direction of the arrow, as shown in the illustration, and release it from the holders. Do not bend the bar at the same time, because it will remain deformed for a long time. Detach the slats from the back of the roof first.
14.1 Turn the bar by hand in the direction of the arrow and release it from the holders
Attention! If the bar is difficult to give in, then use a mounting wedge to remove it, for example, HAZET 1965-20.
2. Remove the adjustable end cap A of the bar (see illustration). After that, feed the bar forward and remove the clips remaining in it.
14.2 Remove the adjustable end cap A of the bar
Installation
3. Attach the rail clips to the roof crease by slightly squeezing them from above (see illustration). Replace damaged clamps with new ones.
14.3 Fasten the rail clips to the roof fold by squeezing them a little from above
4. Put end cap A on the end of the bar (see illustration 14.2).
5. Fasten the bar to the roof, starting from its rear end.
Attention! Install plug A so that it rests on the rear end of the roof fold.