Fig. 3.81. Pressing out the bearing
Press out the bearings using a puller (Fig. 3.81).
Fig. 3.82. Pressing in the bearing
Press in the bearings using a 25 mm diameter bushing (Fig. 3.82).
Fig. 3.83. Removing the secondary shaft bearing cone
Remove the secondary shaft bearing cone using a puller (Fig. 3.83).
Press the cone into place.
Fig. 3.84. Pushing out the outer bearing rings from the crankcase side
Push out the outer bearing rings from the crankcase side using a 55 mm diameter bushing (Fig. 3.84).
Fig. 3.85. Installing outer bearing rings from the crankcase side
Install the outer bearing rings from the crankcase side using a 60 mm diameter bushing (Fig. 3.85).