Contents: Removal 🠛 Installation 🠛
Note: If the hinge pins are tightly seated in their places, then a special Renault 1055-02 tool will be required to remove them.
Removal
1. Disconnect the ground cable from the battery.
Warning! If the radio in your car is coded, make sure you know the code before disconnecting the battery.
2. Loosen the door stop mounting bolt (refer to the accompanying illustration).
3. Lift the retaining bracket and disconnect the door wiring connector from the pillar (refer to the accompanying illustration).
4. Remove the mounting brackets from the upper and lower hinge pins (refer to the accompanying illustration).
This note was copied from the resource: RenaultBook.ru
5a. Have an assistant support the door, then gently tap the top hinge pin down(refer to the illustrations).
5b. Knock the lower hinge pin up (refer to the illustrations).
6. Remove the door from the vehicle.
7. Inspect the pivot pins and bushings for wear or damage and replace if necessary. It is recommended to use new pins during installation.
Installation
1. Lubricate the pins with general purpose grease.
2. Replace the door and drive the pins in completely. Finally, secure them with staples.
3. Connect the electrical wiring connector to the rack and secure it with the bracket.
4. Screw the door stop to the pillar and tighten the bolt securely. Connect the ground cable to the battery.