Before checking:
- - if the automatic transmission pan was removed, fill in 4 liters of transmission fluid or 3.5 liters after a routine change of transmission fluid;
- - if only the transmission fluid level is checked, fill in 0.5 liters of the recommended transmission fluid.
1. The vehicle must be installed on a 4-post lift and the transmission must be at ambient temperature.
2. Set the selector lever to position «R» and start the engine.
3. Connect the XR25 handheld scan tool, enter and D14 or #04.
4. Raise the vehicle and run the engine until the coolant temperature reaches 60°C.
5. When the required temperature is reached, with the engine running, unscrew the inspection plug and drain the excess transmission fluid. Screw the transmission fluid level check plug back into place.
Note. In 20 seconds, 0.1 liters of transmission fluid should flow out.
6. If the excess transmission fluid is less than 0.1 liters, or the transmission fluid level is not normal, add 1 liter of the recommended transmission fluid to the transmission, allow the transmission to cool, and then repeat the above operations.