Contents: Removal 🠛 Installation 🠛
Removal
- on models with central locking, disconnect the cable from the negative terminal of the battery;
Figure 9.53. Disconnecting the contact connector from the lock servo motor
- disconnect the wiring connector from the lock servo motor by pulling it out (Figure 9.53);
Figure 9.54. Removing the anti-theft cover from the door panel
- remove the anti-theft cover from the door (Figure 9.54);
- from inside the door, release the lock and disconnect the control rod from the outer door handle;
- remove the three screws securing the lock from the rear end of the door;
Figure 9.55. Removing the rear door lock
- disconnect the rods of the inner handle and the locking button, remove the lock through the hole in the door (Figure 9.55).
Installation
Installation is carried out in the reverse order of removal.