Removing
- on vehicles equipped with central locking and power windows, disconnect the wire from the negative terminal of the battery;
- detach the inner mirror cover and loudspeaker grille;
Figure 9.34. Removing the power window handle from the front door
- on models with mechanical windows, with the window fully down, remember the position of the window regulator handle and remove the handle from the axle (Figure 9.34);
Figure 9.35. Screw of fastening of an overlay of the internal handle of a door
Figure 9.37. Removing the plug of the screw securing the armrest of the front door
Figure 9.36. Disconnecting the cable end from the inside door handle
Figure 9.38. Removing the front door armrest trim
- unscrew the screws securing the lining of the inner door handle. Remove the handle and disconnect the control cable sheath from the handle, then disconnect the cable end (Figure 9.35 and 9.36). Unscrew the armrest fastening screw, having previously removed its plug, then, gently lifting, slide the armrest pad back to remove it from the door (Figure 9.37 and 9.38);
- on models with power windows, disconnect the wiring connectors from the switches. Disable (if there) pin connector from the mirror electric switch;
Figure 9.39. Removing the loudspeaker from the front door
- unscrew the four mounting screws and remove the loudspeaker from the door, having previously disconnected the wiring connector (Figure 9.39);
Figure 9.40. Removing the screw securing the lower edge of the front door upholstery
- unscrew the screws securing the lower edge of the door upholstery (Figure 9.40);
- carefully, using a flat fork tool, unfasten the plastic upholstery clips around the perimeter of the door;
- remove the trim from the door and lift it over the inner window seal to remove it (around the perimeter it is glued with sealant).
Installation
Installation is carried out in the reverse order of removal. Seal the upholstery around the perimeter with sealant.