Install the jig into the plate (the end of the conductor should enter the hole for the nozzle) for centering the plate.
Fig. 2.156. Installing the injector for cylinders 1 and 3: 1 – bolts; 2 – device; 3 – conductor
Tighten the two mounting bolts. Remove the jig (fig. 2.156).
Install the mandrel instead of the conductor. Insert the nozzle into the mandrel.
Attention! When installing the injector, its tip must be directed towards the center of the cylinder.
Fig. 2.157. Crimping the nozzle: 1 - conductor; 2 – flange
Source is located on the website www.RENAULTBOOK.ru
Apply several blows with a hammer to the mandrel until the flange of the mandrel touches the support (fig. 2.157).