Contents: Removal 🠛 Installation 🠛
Note: To remove the corrector actuator, you must remove the headlight assembly.
Removal
Remove the headlight.
Rotate the motor 1/8 turn outward to disconnect it from the headlight assembly.
Fig. 7.19. Removing the headlight corrector motor: A - protrusion; B – screw
Move the projection A slightly to the side so as not to break it (Fig. 7.19).
By gently rocking the actuator, detach the ball head from the parabolic reflector.
Note: To make separation easier, tighten screw B a few turns (see fig. 7.19).
Installation
Holding the bulb by the base, move the parabolic reflector back away from the headlight.
Snap the ball head into the headlight retainer.
Insert the electric motor into the headlight unit.
Rotate the motor 1/8 turn to secure it into the headlight assembly.
Connect the connector.
Install the lid.
Adjust the headlights.