Removing
Disconnect the connector.
Pic. 7.26. Removing the height sensor of the headlight corrector of the front part of the body: 1 - stopper; 2 - fastening bolt
Remove the stopper and unscrew the bolt securing the height sensor of the front of the body (pic. 7.26).
Installation
Install the sensor with the bracket on the vehicle.
Tighten to 8 Nm the front body height sensor mounting bolt.
Attention! Be sure to replace the stopper after each removal.
Note. The front body height sensor has different electronic characteristics from the rear body height sensor, so it is very important not to confuse them.
Note. The front end height sensor has a yellow mark.
Perform ECU calibration.
Adjust headlights.