Contents: Removal 🠛 Installation 🠛
Removal
Disconnect the battery.
Remove the headlight.
To avoid scratching the headlight, place it on a clean cloth.
Fig. 7.24. Removing the "ECU - high voltage unit" unit: 1 – mounting screws
Remove the screws securing the "ECU - high voltage unit" assembly (Fig. 7.24).
Disconnect the connectors.
Installation
Fig. 7.25. Connection of the xenon lamp ECU connectors
Connect the connectors (Fig. 7.25).
Attention! The high voltage wire harnesses of the right and left headlights are different (the left headlight connector is brown, the right one is blue).
Caution! Be sure to replace the gasket when replacing the ECU.
Tighten the screws securing the "ECU - high voltage unit" unit to the specified torque of 12 N·m.
Install the headlight.
Connect the battery.
Be sure to replace the ECU together with the gasket.
Perform ECU calibration.
Adjust the headlights.