- Disconnect the cable from the negative battery terminal.
- Disconnect the electrical connector from the vehicle height sensor (F, Fig. 15.29).
- Loosen the nut at the end of the rod.
- Remove the two bolts and the mounting nut.
- After replacing the front sensor or anti-roll bar, it is necessary to initialize the system and adjust the headlights.
Attention: Carry out any work with the sensor rod with the front wheels raised to the same height.
- In case of replacement of the anti-roll bar or removal of the flange clamp (G), install the latter at a distance of 10 mm from the left end and install the rod with a gap of e=45±1 mm (fig. 15.35).
- When removing the front power support, be sure to disconnect the rod from the front sensor.
- When installing, tighten the sensor rod to a torque of 3.0 N·m.
Fig. 15.35. Place of measurement of size e=45±1 mm
Caution: When working under the front or rear of the vehicle, disconnect the link from the anti-roll bar and/or cross guide rod.