Removal (first way)
Fig. 8.28. Disconnecting the plug for passing wires in the lower part
Partially disconnect the plug to allow the wires to pass through at the bottom (Fig. 8.28).
Press the locking tab with a screwdriver.
Fig. 8.29. Removing the decorative trim
While holding the tab pressed, slide the trim panel towards the front of the vehicle (Fig. 8.29).
Removal (second way)
Insert the special device (Cag. 1363).
Click on the device.
Fig. 8.30. Removing the decorative trim
Slide the decorative trim towards the front of the vehicle (8.30).
Installation
Secure the plug to allow the wires to pass through.
Installation is carried out in the reverse order of removal.
Fig. 8.31. Pulling out the locking tabs
Note: Before installing the pads, it is necessary to slightly extend the locking tabs (Fig. 8.31).