- bolts of fastening 22, 23, 20, 13 of a cover of a head of the block of cylinders (80 Nm);
- bolts 1-12, 14-19, 21-24 of fastening of a cover of a head of cylinders (120 Nm).
Loosen bolts 22, 23, 20, 13 in the order shown.
Tighten bolts 22, 23, 20, 13 of the cylinder head cover in the specified order to the required torque (120 Nm).
Install the oil separator.
Tighten in the order shown in the figure to the required torque:
- new oil separator bolts (in non-threaded holes) (15 Nm);
- oil separator bolts (new or old) in pre-threaded holes (10 Nm).
Apply 2 mm GRAISSE FLUOREE strips of GRAISSE FLUOREE grease around the inside circumference of the high voltage wire cap to all four ignition coils.
Close the spark plugs.
Torque tighten (25-30 Nm) spark plugs with a set of spark plugs (Ele. 1382).
Install the ignition coils.
Torque tighten:
- ignition coil bolts (in threaded holes) (12 Nm);
- ignition coil bolts (in unthreaded holes) (15 Nm).
Be sure to replace all intake manifold gaskets.
Torque tighten (9 Nm) intake manifold bolts.
Install:
- throttle block;
- air filter housing.