Preparation of piston pins for the K4M engine (Renault Fluence 1)

Check that the piston pins rotate freely in the bosses of the corresponding new pistons.

Use the centering mandrel C 13 and the mounting mandrel A13 from the kit (Mot. 574-22) for piston pins without flange.

Use the centering mandrel C 13 and the mounting mandrel A13-01 from the kit (Mot. 574-24) for piston pins with flange.

Install the piston pin (1) on the mounting mandrel (2) and screw in the centering mandrel (3) until the assembly is tightened.

Install the piston pin (1) on the mounting mandrel (2) and screw in the centering mandrel (3) until…

Loosen the mounting mandrel a quarter turn.

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Podkrepilov Maxim

Share with friends:

Fluence 1: Engine repair

Assembly of connecting rods with pistons of the K4M engine
Installation of connecting rod bearing liners for the K4M engine
Checking the axial displacement of the crankshaft of the K4M engine
Checking the diametrical clearance of the crankshaft main journals…
Installation of main bearing shells for K4M engine

Setting the position of the pistons in relation to the connecting…
Assembly of the piston and connecting rod of the K4M engine
Installing piston rings for the K4M engine
Assembly of the lower part of the K4M engine
Installation of crankshaft seals for the K4M engine