Setting the position of the pistons in relation to the connecting rods of the K4M engine (Renault Fluence 1)

The pistons are marked with a "V" mark on the head, which should be located on the flywheel side.

Position the piston head with the "V" mark (1) facing up.

Direct the connecting rod bearing retaining tab (2) downwards.

Direct the connecting rod bearing retaining tab (2) downwards.

Text of the original source on this website www.Renaultbook.ru

This article is available on: russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article has been reviewed by editor: Podkrepilov Maxim

Share with friends:

Fluence 1: Engine repair

Preparation of piston pins for the K4M engine
Assembly of connecting rods with pistons of the K4M engine
Installation of connecting rod bearing liners for the K4M engine
Checking the axial displacement of the crankshaft of the K4M engine
Checking the diametrical clearance of the crankshaft main journals…

Assembly of the piston and connecting rod of the K4M engine
Installing piston rings for the K4M engine
Assembly of the lower part of the K4M engine
Installation of crankshaft seals for the K4M engine
Installing the cylinder head gasket for the K4M engine