JC5 gearbox
- Clean the area around the oil fill/inspection hole.
- Remove the oil fill/inspection plug.
- Use your finger to check the transmission oil level, which should be at the lower level of the oil filler/inspection hole (pic. 6.3).
Pic. 6.3. Checking the transmission oil level in the JC5 gearbox
Gearbox RK1
- Raise the car.
- Remove the left front wheel.
- The transmission oil level is measured with an oil dipstick (3, fig. 6.4).
Pic. 6.4. Drain plug location (1), fills (2) and feeler gauge (3) for measuring the transmission oil level in the PK1 gearbox
- If necessary, drain the transmission oil and add fresh oil in the required quantity.
Pic. 6.5. Dimensions and location of marks on the dipstick for measuring the transmission oil level in the RK1 gearbox: a - 22±0.5 mm; b - 30±0.05 mm
Note. Cork (2, fig. 6.4) The oil filler hole is not intended to check the oil level at the start of pouring. The angle of the gearbox varies depending on the vehicle it is installed on.
Attention. Under no circumstances should you remove the breather to fill the gearbox with gear oil.
Pic. 6.6. Breather location (1) in gearbox RK1
Pic. 6.7. Dimensions of the protective screen of the radiator of the cooling system