Contents: Removal 🠛 Installation 🠛
Removal
- Disconnect the cable from the negative battery terminal.
- Starting from the corner, lift the upper instrument cluster trim vertically, releasing the three upper clips
- Remove the screws of the rear instrument cluster mounting.
- Loosen the side mounting screws located under the buffers in the sound-absorbing foam.
- Pull the instrument cluster forward.
Fig. 14.8. Removing the heater fan resistor unit
- Disconnect the electrical connectors from the instrument cluster and remove it.
- To access the air distribution unit cover, remove most of the sound insulation.
- Remove the screws securing the left fan cover and remove the cover.
- Disconnect the connector and remove the resistor block.
Installation
- Installation is carried out in the reverse order of removal.