Removing
Cars of the 1st and 2nd stages of production
1. Open the hood and disconnect the wire «masses» from the battery.
2. Disconnect the return spring and remove the hood latch cable.
3. Turn away two bolts and remove the lock from the top cross member of a body.
4. Operating from the passenger compartment, remove the decorative panels to have better access to the lock drive handle.
5. Remove the handle by unscrewing its fastening screw.
6. Tie a long rope or cord to the end of the cable, operating from the engine compartment.
7. Release the cable from its fastening clips in the engine compartment so that you can push it into the passenger compartment with a rope. Untie the rope and leave it in the same place.
Cars of the 3rd stage of production
8. Open the hood and disconnect the wire «masses» from the battery.
9. Remove the grille.
10. Disconnect the return spring and unscrew the screws (one on each side), fastening two locks to the cross member of the body.
11. Turn the locks to the left and remove them. Disconnect the link and control cable of the left lock.
12. Operating from salon, turn away 5 screws and remove a casing of a steering column.
13. Turn away a bolt and remove the cable handle from a steering column.
14. Tie a long rope or cord to the end of the rope. 15 Release the cable from its fasteners in the engine compartment so that you can pull it into the passenger compartment. Pull the cable into the cabin, untie the rope and leave it in this place: you will need it for subsequent assembly.
Installation
All cars
16. Tie a rope to the end of the new cable, pull the cable into the engine compartment and install the fasteners in place. Further installation is carried out in the reverse order of removal.