Visibility limits
The part of the road visible in the headlights was supposed to be a measure of speed when you are driving in the dark. At the same time, good and precisely set headlights increase your safety level. In addition, such light does not dazzle other drivers who are driving towards you.
Lighting test
1. Turn on the ignition and turn on the following lights in turn:
2. Dimensions, dipped beam, fog lights, high beam headlights and, if necessary, an additional high beam headlight.
3. Front, right and left turn signals and emergency signal.
4. Tail lights, license plate lights and rear fog lights.
5. Turn signals behind right and left, emergency signal, reversing lights.
6. Stoplight, for this you need an assistant.
Replacement lamps on the road
The following incandescent lamps must be included in the spare lamp kit:
- Double-filament halogen lamp H4 H 4, 60/55 W (main headlights).
- Ball bulb, 21 W, with DIN socket form RL (turn signal front and rear; reversing lights; rear fog lights).
- Bulb with ball bulb 2 filaments, 21/5 watts, DIN socket form SL (stop signal).
- Globe bulb, 5 W, with DIN base form HL (dimensions; side turn indicators).
- Soffit lamp, 5 W (license plate lighting).
Replacing headlight bulbs
After removing the cover (2) disconnect in the headlight housing (1) terminal connection (4). After removing the spring (3) The bulb can be pulled out of the headlight reflector. If you need to replace the side light bulb (5), remove the bulb holder with plug connection from the reflector.
All bulbs in the headlights are removed from the engine compartment. After replacing headlight bulb (marker lights lamps) it is not necessary to check the adjustment of this headlight.
1. Squeeze out the safety clip at the top of the housing cover and open the housing.
2. Remove the three-pin wire connector from the back of the headlight.
3. Unhook the lamp spring.
4. Remove the damaged lamp from the reflector.
5. A new incandescent lamp must be inserted so that its 3 tabs of the terminals of the connector block form a letter open down «U».
6. When installing the shroud, make sure both lower tabs are properly seated in the lamp body.
Lamp dimensions
1. Squeeze out the safety clip on the casing cover and fold it out.
2. Turn the frame of the double-filament lamp of dimensions 45°to the left counterclockwise and remove it from the reflector.
3. Remove the incandescent lamp from the frame.
4. Make sure that when installing the frame of the lamp of dimensions, both of its retaining protrusions, when rotated clockwise, are correctly fixed in the reflector.
5. Check her work.
6. When installing the shroud, make sure that both lower tabs of the bezel are properly seated on the lamp body.
Note. Recommendation: before throwing away a suspected broken incandescent light bulb, check it. Maybe it is working and she does not have enough power or she has poor contact with the ground.
Do not touch the glass of new or serviceable incandescent lamps with your fingers. Sweat particles will definitely remain on the lamp. They will evaporate from a hot lamp and, hitting the reflector, will make it dimmer. Therefore, when installing the lamp, use a clean handkerchief.