Lighting control (Renault Fluence 1)

Side lights

Turn ring 2 until the symbol appears opposite mark 3. The corresponding indicator lamp on the instrument panel will light up.

Low beam headlights

Manual mode: Turn ring 2 until the symbol appears opposite mark 3. The indicator light on the instrument panel will come on.

Automatic mode: Turn ring 2 until the "AUTO" symbol appears opposite mark 3. When the engine is running, the low beam headlights are switched on and off automatically, depending on the level of light outside, without any action on the lever.

High beam headlights

With the low beam headlights on, move the switch lever 1 towards you. The indicator light on the instrument panel will light up.

[Original of this article on the website www.RENAULTBOOK.ru]



To turn the low beam headlights back on, move switch lever 1 towards you again.

Directional headlights: If the low beam headlights are switched on manually and the outside light level is sufficient, the direct beam headlights remain stationary.

If the headlights turn on automatically while you are making a turn, the directional headlights will turn on when you make the next turn.

When the low beam headlights are turned on, with the engine running, on a stationary vehicle, they move, which means that the system is being re-initialized. Otherwise, it indicates a malfunction.

Turning off the headlights

Manually move ring 2 to position 0.

The headlights are automatically switched off after the engine is stopped, when the driver's door is opened or the car is locked. In this case, when the engine is subsequently started, the headlights will be switched on in the mode corresponding to the position of ring 2.

"Light Accompaniment" function

After stopping the engine and turning off the headlights, turn ring 2 to position 0, pull the switch lever 1 towards you: the low beam headlights will turn on for approximately thirty seconds. To increase this period, pull the switch lever up to four times (the total time is limited to two minutes). Depending on the vehicle's configuration, a message is displayed on the instrument cluster to confirm that this function is enabled "Se-eme-home _ _ _" indicating the operating time of the headlights. To switch off the lighting before it switches off automatically, turn ring 2 and set it to position 0.

Sound signal to remind you that the light is not turned off

If the headlights were on after the engine was stopped, a chime will sound when the driver's door is opened, reminding you that the lights are on.

Fog lights

Turn the middle ring 5 of the steering column switch lever 1 to the position where the mark 6 is aligned with the corresponding symbol, then release the ring. The rear fog light comes on if the exterior lights are on; at the same time, the corresponding signal lamp on the instrument panel lights up.

Rear fog light

Turn the middle ring of the steering column switch lever 5 to the position where mark 6 aligns with the corresponding symbol, then release the ring.

Turning off outdoor lighting

To switch off the fog lights or the rear fog light, turn ring 5 again, aligning mark 6 opposite the corresponding symbol.

The corresponding indicator light on the instrument panel will go out.

When the exterior lighting is switched off, the fog lights and rear fog light are switched off at the same time.

Adjusting the headlights in the vertical plane

For vehicles with this function, regulator A allows you to adjust the direction of the light beams in height depending on the vehicle load.



Turn knob A downwards to lower the headlight beams, or upwards to raise them.

For vehicles that are not equipped with regulator A, adjustment occurs automatically.

Light regulator positions depending on vehicle load