Vehicle equipped with a rain-sensing front wiper
- A - stop
- B - automatic activation of the wipers
After setting the lever to this position (when water drops appear on the front glass) the windshield wiper switches on automatically at the appropriate speed. In this case, you can change this switch-on threshold, as well as the time between cleaning the glass, by turning ring 2:
- E: minimum sensitivity.
- R: maximum sensitivity.
Wiper operating modes:
A - stop;
B - intermittent mode;
C - continuous operation with low frequency;
D - continuous operation with high frequency
Windshield washer
With the ignition on, pull switch lever 1, then release it.
In addition to the washer, a short reciprocating motion of the wiper is activated.
In addition to the washer, three reciprocating wiper strokes are activated, followed by another wiper stroke a few seconds later.
Headlight washers
With the headlights on, hold the handle 1 pulled out for about 1 second.
Note. When the minimum washer fluid level is reached, the headlight washer circuit may be cut off.