Contents: Manual opening from outside the…🠛 Manual opening from inside 🠛 Driver's responsibility 🠛 Childproof door lock 🠛 Sound signaling device for external…🠛 Manually locking/unlocking door locks 🠛 Central lock 🠛 Enabling the function 🠛 Disabling the function 🠛 Malfunctions 🠛 Signal lamp 🠛
Manual opening from outside the vehicle
Driver's door: open the lock with key 2. Grasp handle 1 from below and pull it towards you.
Manual opening from inside
Lift door lock button 3 and pull door handle 4.
Driver's responsibility
When leaving the car, do not leave the key in the car if there is a child in the car (or an animal), even for a short time.
A child or animal may harm themselves or others by starting the engine, operating equipment such as windows, or locking doors.
Childproof door lock
To prevent the rear doors from being opened from the inside, move lever 5 on each door, close the doors and check the reliability of their locking from the inside.
Sound signaling device for external lighting not switched off
If you leave the exterior lights on and turn off the ignition, when you open the driver's door, an audible signal will sound, warning of a possible discharge of the battery, etc.
Manually locking/unlocking door locks
Front doors: From the outside use the driver's door key, inside press button 1 on the closed door.
Rear doors: Press button 1 of each door.
Central lock
This drive allows you to simultaneously lock the side doors and the tailgate.
(This note was copied from the resource: RENAULTBOOK.ru)
Lock the doors by pressing the red dot on switch 2.
The front door lock cannot be locked if the door is open.
When leaving the car, do not leave the key inside.
If you decide to drive with the doors locked, remember that this may make it difficult for rescuers to enter the vehicle from the outside in an emergency.
First of all, you need to decide whether you need to use this feature.
Enabling the function
Turn on the ignition, press the central locking switch 1 on the locking side (red dot) and hold it down for about 5 seconds until you hear a short beep.
Disabling the function
Turn on the ignition, press the central locking switch 1 on the unlocking side (opposite the red dot) and hold it down for about 5 seconds until you hear a short beep.
If you decide to drive with the doors locked, remember that this may make it difficult for rescuers to enter the vehicle from the outside in an emergency.
Operating principle
When the vehicle starts moving, the system automatically locks the opening elements of the body when the speed reaches 10 km/h.
The locks are unlocked:
- when you press button 1 to unlock the doors;
- when stopping, if you open any door.
Note: An unlocked rear door will automatically relock when the vehicle speed reaches approximately 10 km/h.
Malfunctions
If you have detected a malfunction, first check whether all opening body elements are tightly closed. If they are tightly closed, contact the manufacturer's service station.
Also make sure that the automatic locking function has not been disabled by mistake. If this has happened, enable the function as described above.
The system makes it impossible for a person who does not have the coded ignition key for the vehicle to start the engine.
The electronic engine immobilizer system is activated automatically a few seconds after the key is removed from the ignition switch.
Operating principle
If the ignition key code is not recognised by the electronic engine immobiliser system, warning lamp 1 flashes rapidly and the engine cannot be started.
Operations with the electronic engine start interlock system or making changes to its design (electronic units, electrical wiring, etc.) may be dangerous. Work must be carried out by qualified specialists of the manufacturer's service station.
Signal lamp
Operation of the signal lamp when the ignition is turned on
When the ignition is switched on, the indicator lamp 1 lights up without flashing for about three seconds, then goes out. The car has recognized the code. You can start the engine.
Operation of the signal lamp when the system is turned on
A few seconds after the ignition is switched off, indicator lamp 1 starts to flash continuously.
The electronic engine immobilizer system is activated only after the key is removed from the ignition switch.
Operation of the warning light in case of a malfunction of the electronic engine start immobilizer system
If after the ignition is switched on, indicator lamp 1 continues to flash or remains lit, this indicates a system malfunction.
In case of any malfunctions, you should definitely contact the service station of the manufacturer, since only employees of this station are authorized to repair the electronic engine start interlock system.
If the coded ignition key is faulty, use the spare key that you received when you purchased the vehicle.