Removing
Make sure the wiper motor is in the correct position on the windshield. Disconnect the battery.
Remove:
- left and right wiper arms 1;
- washer fluid reservoir seal 2;
- washer fluid reservoir cap 3 on the left side.
Unscrew the bolts securing the wiper drive assembly with the electric motor.
Disconnect the motor connector.
Remove the wiper motor assembly.
Turn out bolts of fastening of the electric motor.
Installation
Install the motor, connect the motor connector, and connect the battery. bring the electric motor 8 to the position corresponding to the initial position of the brushes on the windshield by turning on the ignition. The moment of an inhaling of bolts of fastening of the electric motor: 8 Н·м.
Clean the splines of the lever axles 5.
Install the wiper arms and adjust their position according to marks 4.
Screw on new nuts of fastening of levers and tighten them with the moment of 20 Нм.
Connector pin assignment
The motor connector pins on right-hand drive and left-hand drive vehicles have the same function.
1. «Weight».
2. Electromagnetic reverse braking and electric motor.
3. Not used.
4. Power supply when running at low speed.
5. Power supply when running at high speed.