General information
Depending on the vehicle configuration, two types of displays are installed.
Display for 8 basic models with the following functions:
- control lamp for closing opening elements;
- tire pressure indication;
- car radio screen;
- seat belt reminder light.
Display for fully equipped models with Carminat navigation system with the following functions:
- navigation;
- tire pressure monitoring.
Display for basic models: The holder is installed on the instrument panel. Both displays are installed on this holder.
Display for fully equipped models: the holder is secured with two screws.
Note: At outside temperatures between -3°C and +3°C, the "C" symbol may flash.
Assigning contacts
The pin assignment applies to the display for base models only.
15-pin green connector:
- 1. Multiplex communication.
- 2. Not used.
- 3. Multiplex communication.
- 4. Not used.
- 5. "Mass".
- 6. "+" after ignition switch.
- 7. The safety belt warning light switch is not attached.
- 8. Tire pressure signal (from the gray connector).
- 9. Not used.
- 10. Not used.
- 11. Not used.
- 12. Not used.
- 13. Not used.
- 14. Not used.
- 15. Not used.
15-pin red connector:
- 1. Not used.
- 2. Not used.
- 3. Not used.
- 4. Not used.
- 5. Not used.
- 6. Not used.
- 7. Not used.
- 8. Not used.
- 9. Connection with car radio (contact B1).
- 10. Connection with car radio (contact AZ).
- 11. Communication with car radio (contact B2).
- 12. Communication with car radio (contact VZ).
- 13. Communication with car radio (contact A2).
- 14. Communication with car radio (contact A1).
- 15. Not used.
15-pin gray connector:
- 1. Outside temperature.
- 2. Outside temperature.
- 3. Tire pressure signal (on the green connector).
- 4. Not used.
- 5. "Mass".
- 6. Lighting.
- 7. Power supply for backlight lamps (regulator).
- 8. "+" of electricity consumers.
- 9. "+" of the battery.
- 10. Outside temperature sensor output.
- 11. "Mass" (car radio, contact 6).
- 12. Car radio on signal (car radio, contact 5).
- 13. Connection with car radio (contact 1).
- 14. Connection with car radio (contact 2).
- 15. Connection with car radio (contact 3).
Connection
- A1. Signal from the fuel level sensor.
- A2. Not used.
- 81. "-" fuel level sensor.
- 82. Not used.
- C1. "+" fuel pump.
- C2. "-" fuel pump.
Examination
Make sure that the resistance of the sensor changes when the float moves.
View the original on the specified resource (www.RenaultBook.ru)
Note: All values given are for reference only.