Attention! In order to prevent a sharp expansion of the spring, it is forbidden to remove both bolts of the lower ends of the shock absorbers at the same time.
Removing
Place the car on a two post lift.
Remove the wheels and spring cup covers A.
Place a hydraulic jack under the lower spring cup.
Remove:
- shock absorber lower end bolt B;
- shock absorber upper end bolt.
Do the same with the other shock absorber.
Mark the position of the spring, this will facilitate its installation.
Unload and remove the spring by lowering the rear suspension beam.
Installation
Install in the reverse order of removal, observing the position of the spring.
Note. If xenon lamps are installed on the vehicle, they must be initialized.