Remove the floor mat.
Disconnect the battery.
Remove:
- driver's frontal airbag;
- steering wheel.
Loosen the screws (1) fastenings of steering-wheel facing casings.
Set the steering column to the down position.
Remove the top stalk facing casing.
Set the steering column to the top position.
Remove the bottom cover.
Remove the bolt (2), without removing it.
Release the steering column switch box by operating the flat blade screwdriver as a lever at the point (3).
Remove the steering column switch block.
Disconnect the steering column switch connectors.
Note. In case of replacement, do not remove the pin (4) paddle switches.
Remove the lower trim of the dashboard (see section «electrical equipment»).
Remove the front air supply pipe to the legs (see section «electrical equipment»).
To access the terminal connection of the steering shaft cardan yoke, fold the floor mat.
Remove the bolt (1) terminal connection of the universal joint of the steering shaft.
Remove the universal joint yoke.
Disconnect connector (2) electric steering column lock.
Disconnect steering column connectors (3).
Disconnect the wiring harness from the steering column.
Remove (fastening nuts 4) and steering column.
Install the steering column.
Tighten the steering column nuts in the order shown to 21 Nm.
Fix a wire in clips of a steering column.
Attach:
- steering column connectors;
- connector for electric steering column lock.
Note. Check that the connector locking device is securely fastened.
Install the universal joint yoke to the steering mechanism without changing its position by more than one tooth from its original position.
Torque tighten the bolt of the terminal connection of the steering shaft universal joint yoke on the steering mechanism 62 Nm.
Install the floor mat.
Install the parts in reverse order.