Removing
1. Disconnect the ground wire terminal (-) from the battery.
Attention! At the same time, some data is deleted from the memory of storage devices, for example, an access code is erased from the radio receiver, which prevents unauthorized use of the receiver. Before disconnecting the battery, read the instructions in chapter «Removing and installing the battery».
2. Remove the steering wheel.
Attention! At the same time, observe the precautions regarding airbags.
3. Remove facing of a steering column. In this case, first remove the lower part of the cladding by unscrewing the three screws C and pushing the cladding down (see illustration).
30.3 Remove the three screws from the bottom of the steering column trim
4. Unscrew the three screws E, which secure the upper part of the steering column trim, and remove the trim (see illustration).
30.4 Unscrew the three screws E that secure the upper part of the steering column trim
5. Remove the glass cleaner switch. To do this, disconnect the plug, unscrew the screws 1 and move the switch to the right side of the steering column (see illustration).
30.5 Remove the glass cleaner switch
6. Remove the turn signal switch. To do this, disconnect plug 2, unscrew screws 1 and move the switch to the left side of the steering column (see illustration).
30.6 Remove the turn signal switch
7. Remove the holder of the steering column switches by unscrewing the bolt F (see illustration). After that, remove the holder from the steering shaft along with the spiral.
30.7 Remove the holder for the steering column switches by unscrewing the screw F
Installation
8. Put the holder of the steering column switches on the steering shaft and fix it with the bolt F (see illustration 30.7).
9. Connect to the holder steering column switches.
10. Connect the multi-pin plug.
11. Establish into place facing of a steering column.
12. Reinstall the steering wheel.
13. Connect the wire terminal «masses» (-) to the negative pole of the battery.
14. Set the clock and program the radio.
15. Check the operation of the steering column switches.