Front airbag
Disconnect the battery.
Remove:
- screws for fastening the steering column trim covers;
- steering wheel hoods.
Insert a flathead screwdriver into the hole (1), located behind the steering wheel.
Detach the driver's front airbag from the clips by pushing in the direction of the arrow (2).
Unlock at the point (3) driver's front airbag connectors (4).
Disconnect wire connectors (4) driver's frontal airbag.
Remove the driver front airbag.
Attention. To prevent the airbag module from deploying, store it with the airbag upside down.
Make sure there are no foreign objects between the steering wheel and the driver's frontal airbag (anti-rotation pin for steering column switches, etc.).
Connect the driver front airbag connectors. Lock the driver front airbag connectors. Install the driver's frontal airbag on the steering wheel.
Attach the front airbag.
Check that the front airbag is securely attached to the steering wheel: try to detach the driver's front airbag by pulling it up.
Steering wheel
Remove the bolt (1) steering wheel mountings.
Remove the steering wheel.
Attention. To avoid damaging the contact disk, do not rotate its moving part.
Replace steering wheel bolt.
Make sure the pointer (3) combined with latches (4).
Make sure the pointer is visible in the slot (5).
Install the steering wheel. Connect the connectors.
Install a new steering wheel bolt.
Torque tighten the new steering wheel mounting bolt 44 Nm.
Turn on the ignition.
Check the operation of the contact disk:
- turn the steering wheel to the extreme left position;
- turn the steering wheel to the extreme right position;
- check that there is no fault message displayed on the instrument cluster.