Remove the left front wheel and front bumper.
Remove the left front fender liner.
Loosen the power steering pump mounting bolts.
Install the clamp on the power steering pump hose.
Loosen the high pressure pipe fitting on the power steering pump.
Remove clamp (1) and disconnect the high pressure fuel line (2) from the electric power steering pump.
Connect the hose (Dir. 1798) to the opening of the electric power steering pump and the opening of the high pressure pipe of the electric power steering pump.
Install the high pressure pipe union and hose bolt (Dir. 1798) to the power steering pump. Torque tighten (21 Nm) high pressure pipe fitting bolt on the power steering electric pump.
Connect pressure gauge (Mot. 836-05) to the hose (Dir 1798) with a fitting «WITH».
Remove the clamp.
Lower the car.
Fill the power steering system with oil (type ELF RENAULT MATIC D2).
Bleed the air from the system by turning the steering wheel from one end to the other first with the engine off.
Bleed air from the system by turning the steering wheel from one end to the other while the engine is running.
Top up the oil level in the reservoir if necessary.
Check the pressure developed by the electric power steering pump with the steering wheel turned to the end position, the maximum value should be 90 bar. Stop the engine.
Raise the vehicle.
Install the clamp on the power steering pump hose.
Remove pressure gauge (Mot. 836-05) and fitting «WITH».
Loosen the hose bolt (Dir. 1798) and the high pressure pipe fitting on the electric power steering pump. Connect the high pressure fuel line connector to the power steering pump.
Install the high pressure pipe fitting bolt on the power steering electric pump.
Torque tighten (21 Nm) high pressure pipe fitting bolt on the power steering electric pump. Remove the clamp.
Fill the power steering system with oil (type: ELF RENAULT MATIC D2).
Bleed the air from the system by turning the steering wheel from one end to the other first with the engine off.
Bleed air from the system by turning the steering wheel from one end to the other while the engine is running.
If necessary, bring the fluid level in the power steering reservoir to normal.
Make sure there are no leaks.
Install:
- bolts of fastening of the electric pump of the amplifier of a steering;
- left front fender liner;
- front bumper;
- left front wheel.