Contents: Removal 🠛 Installation 🠛
Removal
- Remove the gearbox.
- Remove the clutch housing with the pressure plate and the driven clutch disc.
- Using the Mot.852 tool, block the flywheel from turning (fig. 5.3)
- Loosen the flywheel mounting bolts (bolts should not be reused).
- Remove the flywheel and tool Mot. 582.
- It is not allowed to ream the flywheel surface for the driven clutch disc
- If the flywheel is damaged or worn, replace it.
Installation
- Use a dry cloth to clean the threaded holes in the crankshaft flange for the flywheel mounting bolts.
- Degrease the surface of the crankshaft flange under the flywheel.
- Install the flywheel, lubricating the place where it fits with Loctite AUTOFORM locking compound.
- Apply Loctite FRENETANCH to new bolts and tighten finger tight.
- Using the Mot852 tool, lock the flywheel from turning (fig. 5.3).
- Tighten the flywheel mounting bolts to 60 Nm.
- Remove tool Mot. 582.