- right rear wheel;
- left rear wheel;
- right front wheel;
- left front wheel.
Do not operate the anti-lock braking system unless it has been bled. If the injection pump sucks in air, it will be extremely difficult or impossible to remove.
In this regard, a hydraulic unit filled with brake fluid is supplied as spare parts.
It is best to bleed the system under pressure using a bleeder tool, especially after removing the ABS hydraulic unit and/or brake master cylinder.
Removal air using a special device
- Connect the bleeding device to the brake fluid reservoir and apply a pressure of 2 bar
- On each wheel cylinder, attach a tube to the air bleed nipple.
- Open the bleed screw and press the brake pedal until the brake fluid starts to come out without bubbles.
- Close the air bleed nipple.
- The following order of air removal operations must be strictly observed:
a) master brake cylinder to the right rear wheel;
b) master brake cylinder to the left rear wheel;
c) the master brake cylinder to the right front wheel,
d) the main brake cylinder to the left front wheel.