Tightening torques | |
Alternator mounting bolts | 21 Nm |
Nut of fastening of a positive conclusion on the generator | 14 Nm |
Removing
Place the car on a two post lift.
Disconnect the battery.
Remove:
- right front wheel
- accessory drive belt.
Disconnect fitting (3) fuel supply line from the fuel rail.
Disconnect the wires (4) from the generator.
Set aside the alternator wiring harness.
Loosen the top bolt (8) generator mounts.
Loosen the alternator lower mounting bolt (9).
Move the generator away from the multi-function bracket using a screwdriver.
Remove the alternator with the lower mounting bolt through the top of the vehicle.
Installation
Push bushings in for easier installation (10).
Install the generator.
Torque tighten the alternator mounting bolts (21 Nm).
Connect the wires to the generator.
Torque tighten the positive terminal nut on the alternator (14 Nm).
Connect the fuel inlet fitting to the fuel rail.
Install:
- accessory drive belt,
- right front wheel.