Removing
Disconnect the wire blocks (1) from ignition coils.
Remove:
- fastening bolts (2) ignition coils,
- ignition coils.
Installation
Be sure to replace the ignition coil mounting bolts.
If necessary, replace the sealing rings of the ignition coils.
When installing high voltage wires, be sure to apply a bead of FLUOSTAR 21, 2 mm in diameter, around the inside circumference of the high voltage wire caps on the spark plug and ignition coil side.
Install:
- ignition coils,
- new ignition coil bolts.
Torque tighten the ignition coil mounting bolts (14 Nm).
Connect the ignition coil connectors.