Tightening torques | |
Starter mounting bolts | 44 Nm |
Nut of fastening of an output of a starter | 8 Nm |
Nut of fastening of a wire of the electromagnetic valve of a starter | 5 Nm |
Removing
Place the car on a two post lift.
Disconnect the battery.
Remove the intake silencer.
Disconnect:
- cables for selecting and shifting gears from the gearbox at points (3) with a screwdriver,
- stoppers of the sheaths of the select and shift cables on the gearbox by pressing in (4).
Remove:
- fastening nut (5) starter solenoid wires
- fastening nut (6) starter wires,
- starter mounting bolts (7),
- starter through the bottom of the car.
Installation
Check for the presence of the mounting sleeve.
Install:
- starter through the bottom of the car,
- starter mounting bolts.
Torque tighten the starter mounting bolts (44 Nm).
Install:
- starter wires,
- starter cable nut
- starter solenoid valve wire nut.
Torque tighten:
- starter terminal nut (8 Nm),
- starter solenoid valve wire nut (5 Nm).
Fasten:
- stoppers for the sheaths of the select and shift cables on the gearbox,
- cables for selecting and shifting gears on the gearbox,
- block of protection and switching.
Connect the battery.