Tightening torques | |
Alternator mounting bolts | 21 Nm |
Nuts of fastening of a wire of the generator | 14 Nm |
Removing
Place the car on a two post lift.
Disconnect the battery.
Remove:
- front bumper,
- accessory drive belt,
- dowel pins (1) air baffle,
- air baffle.
Remove the top fasteners (4) electric fan of the engine cooling system.
Remove the engine cooling fan assembly with the cooling system radiator and condenser from the lower mountings (3) and move to the left.
Remove:
- alternator cable nut
- the wire (4) from the generator.
Disconnect the wiring harness (5) from the generator.
Loosen the top bolt (6) generator mounts.
Loosen the alternator lower mounting bolt (7).
Move the generator away from the multi-function bracket using a screwdriver.
Remove the alternator together with the lower mounting bolt.
Installation
Push bushings in for easier installation (8).
Install the generator.
Torque tighten the alternator mounting bolts (21 Nm).
Connect the generator connector.
Install:
- generator electric wire,
- alternator cable nut.
Torque tighten the alternator wire fastening nuts (14 Nm).
Slide the engine cooling fan assembly with the cooling system radiator and condenser to the right and install on the lower mounts.
Establish the top fastenings of the electrofan of the engine cooling system.
Install:
- air baffle,
- accessory drive belt.
Connect the battery.