Contents: Removal 🠛 Installation 🠛
Tightening torques: Generator pulley - 80 Nm.
Removal
Place the vehicle on a two-post lift.
Remove:
- accessory drive belt,
- generator.
Disconnect the generator pulley guard (if installed).
Secure the generator in a vice with soft jaws.
Install the hex head (1) or slotted head (2) from the kit or into the alternator pulley (depending on the model).
 |
 |
Note: Be sure to use a pneumatic or electric impact wrench to loosen the alternator pulley.
Loosen the alternator pulley using a pneumatic or electric wrench.
 |
 |
Remove:
- devices,
- generator pulley.
Parts that must be replaced:
- Accessory drive belt
- Accessory Drive Belt Idler Pulley
- Auxiliary Drive Belt Tensioner
- Auxiliary Drive Belt Tensioner Roller Fastening Bolt
- Generator pulley
Installation
Installing the generator pulley.
Tighten the new alternator pulley.
 |
 |
Original publication on the website (www.RenaultBook.ru)
Install:
- hex head (3) or slotted head (6) into the generator pulley (depending on the model),
- tip (4) into the protrusion on the generator rotor,
- holder (5) of the device on the tip.
Secure the generator rotor with the key (7).
Tighten the alternator pulley to the specified torque (80 Nm) using a torque wrench (8) with a 15 mm fork-type torque wrench.
Remove the devices.
Secure the new guard to the alternator pulley (if installed).
Install:
- generator,
- accessory drive belt.
Connect the battery.