and 
are used to restore the seat adjustment parameters that are stored in the memory switch 
provides movement of the seat cushion (in the longitudinal direction and in height), and the switch 
- seat backs (by angle of inclination).
The electric seat adjustment system operates under the following conditions:
- ignition on;
- the driver's door is open. (Moreover, electric adjustment of the seats is possible within 4 minutes).
Caution! When adjusting the driver's seat, the buttonmust be in the on position (recessed).
Adjusting the seat cushion position using the switch 
To move forward: Move the switch handle forward.
To move backward: Move the shift handle backward.
To raise the seat cushion: Slide the rear of the switch handle up.
To lower the seat cushion: Slide the rear of the switch handle down.
Adjusting the seat backrest angle using the switch 
To change the backrest angle: Move the switch handle forward or backward.
Caution: For safety reasons, adjust the seats only when the vehicle is stationary.
Memorizing driver's seat positions
Your vehicle has the ability to memorize three positions of the driver's seat.
To turn on the storage device, press button B. The device can operate under the following conditions:
- ignition on;
- the single door lock is disabled using the remote control. (The memory device can be used for 15 seconds after the doors are unlocked). A short press on one of the three C buttons automatically restores the seat pre-adjustment parameters stored in the memory;
- the driver's door is open. (The storage device can be used for 4 minutes).
The procedure of memorization
Click the button
to turn on the storage device: in the on position, the button 
drowned.
Note. For safety reasons, the memory device records only the "working" positions of the driver's seat that are suitable for driving the car. Reclining seat back positions (at large angles of deviation from the vertical), usually used for recreation, are not remembered by the device.
Once the seat position is properly adjusted, press the long button and then immediately press one of the buttons marked 1, 2 or 3.
- 1 First seat position
- 2 Second seat position
- 3 Third seat position
Turn off the storage device by pressing the button again
.
Setting the seat to a position fixed by the memory device
- a) turn on the storage device by pressing the button
. - b) Press one of the buttons marked 1, 2 or 3, which corresponds to your seat installation option. Keep the button pressed until the seat automatically reaches the desired position.
Note: If you have turned on the automatic seat adjustment system (with a short press of the button) within 15 seconds after unlocking the single electric lock using the remote control, wait until the adjustments are completed and only then start the engine. Do not touch the adjustment control buttons, otherwise the process of automatically setting the seat to the desired position will be interrupted.
- c) Click on the button
to switch off the memory device or interrupt the automatic seat setting, if necessary.