Removing
Place the car on a two post lift.
Remove:
- bolts of fastening of protection of the pallet crankcase of the engine,
- protective screen.
Working from below the vehicle, disconnect the connector (1) crankshaft position sensor.
Remove through the bottom of the car:
- bolt (2) fastening the crankshaft position sensor of the engine,
- engine crankshaft position sensor.
Installation
Install the crankshaft position sensor.
Torque tighten the crankshaft position and speed sensor mounting bolt (8 Nm).
Connect the engine crankshaft position sensor connector.
Install the engine undertray.