Contents: Removal 🠛 Installation 🠛
Removal
Open the hatch on the door trim.
Remove the outer window sill seal using a special tool (Cag. 1363).
Fig. 8.83. Installing the glass in a position that allows access to the holder: 1 – holder
Position the glass so that the holder is accessible (Fig. 8.83).
Fig. 8.84. Removing the protrusion: 1 - ledge
Remove the tab by pulling the glass upwards (Fig. 8.84).
Remove the upholstery with an upward movement.
Move it to the side and remove the window lift sliders from the door frame at the bottom.
Fig. 8.85. Removing the door trim
Remove the upholstery by sliding it down (Fig. 8.85).
Disconnect the B-pillar connector.
Fig. 8.86. Disconnecting the holders: 1 - ledge
Disconnect the holders (Fig. 8.86).
Remove the door trim assembly with the window lift motor and wiring harness.
Lower the glass into the door frame.
Remove the glass from the door pillar groove.
Installation
Installation is carried out in the reverse order of removal.