Luggage compartment under the passenger seat
1. Move the front passenger seat forward as far as it will go. Turn away bolts (A) securing the trunk lid.
2. Move the front passenger seat back as far as it will go. Turn off the bopts (IN) securing the trunk lid.
Side overhead handle
1. Remove the bolts (A), do not remove the bolts from the housing.
2. Trample the bopt along the strap (1) to release the fasteners (IN), remove the handle.
Collision Energy Absorber (front door)
1. Remove front door trim panel
2. Unfasten the clips with a small screwdriver (A) energy absorber mounts.
3. Raise the energy absorber (1) and take it out through the panel opening in the direction of the arrow (2).
Seat belts
A. Front seat
1. Remove the front seat.
2. Turn away fastening of the top and lower support of a seat belt.
3. Remove an overlay of an average rack in the direction of an arrow (1).
4. Partially remove the front door sill trim at the belt (arrows 3 and 4).
5. Remove the bolt (A) inertial coil supports.
6. Remove the foot (IN) inertial coil bracket from under the inner panel of the center pillar.
B. Rear seat
1. Remove a pillow and a back of a back seat.
2. Remove finishing of a back shelf.
3. Turn away bolts of fastening of a belt and remove a belt and the coil.
C-pillar trim
Disconnect the glass heater wires.
Gently pull the trim from the top (1).
Remove holders (A).
Lift the trim to release it from the guides (IN).
Wheel arch trim
Remove:
- Christmas tree fixer (A).
- fixing bolt (IN).
Rear wing trim
Remove:
- four holders (A), using pliers to remove upholstery and trim holders,
- holder (IN), using a flathead screwdriver.
Rear seat back
Remove the two seat back bolts (A).
Move the seat back up to release it from the rails (IN).