- disconnect the wire from the negative terminal of the battery;
- remove the front bumper and grille (see section «Body»);
Pic. 8.19. headlight mounting bolts
- remove the headlight bolts (pic. 8.19);
- Disconnect the connectors and remove the headlamp.
Installation is carried out in the reverse order of removal.
After installation, it is necessary to adjust the beam of headlights. To do this, do the following:
- park the car on level ground (do not apply the parking brake);
- make sure that the car is not loaded, the fuel tank must be full (if possible);
- set the headlight range control knob to position «0»;
Pic. 8.20. Headlight Beam Adjustment Screws: A - in the vertical plane; B - in the horizontal plane
- adjust the headlight beam as shown below. Screws for adjusting the direction of the headlight beam are shown in fig. 8.20.