- on models with central locking, disconnect the wire from the negative terminal of the battery;
Pic. 9.53. Disconnecting the connector from the lock servo motor
- disconnect the wiring connector from the lock servo motor by removing it (pic. 9.53);
Pic. 9.54. Removing the anti-theft cover from the door panel
- unfasten the anti-theft cover from the door (pic. 9.54);
- from the inside of the door, release the latch and disconnect the control rod from the outer door handle;
- unscrew the three screws securing the lock from the rear end of the door;
Pic. 9.55. Removing the rear door lock
- disconnect the rods of the inner handle and the lock button, remove the lock through the hole in the door (pic. 9.55).
Installation is carried out in the reverse order of removal.
Removal and installation of internal door handles
Removal and installation of internal door handles are described in subsections «Removal and installation of an upholstery of a forward door», «Removal and installation of an upholstery of a back door».