The central control lamp of an emergency status
STOP
The control lamp lights up after inclusion of ignition and dies away after engine start. If the warning light comes on while driving, stop the vehicle immediately. The warning lamp may come on alone or together with other warning lamps.
Engine oil pressure warning lamp
The control lamp lights up after inclusion of ignition and dies away after engine start. If the lamp does not light up after turning on the ignition. means that its functioning is disturbed or the lamp burned out. If the warning lamp lights up while driving, stop, turn off the engine and check the engine oil level:
- if the oil level is normal, check the lubrication system;
- if the warning lamp is on, despite the fact that the engine oil level is normal, you must not continue driving, as the engine will be seriously damaged.
A control lamp of low level of a brake liquid
The control lamp can burn for two reasons:
- if the parking brake is applied when the ignition is switched on. After releasing the parking brake lever, the control lamp should go out;
- if the level of brake fluid in the reservoir of the brake system is low.
8 In this case, stop the car. check the brake fluid level and. if necessary, bring it up to normal. If you have to frequently top up the brake fluid, then the hydraulic drive of the brake system is leaky and there is a constant leakage of brake fluid. In this case, you should immediately find the nearest service company to check the service brake system.
Battery charging control lamp
The control lamp lights up at inclusion of ignition and after start-up of the engine dies away. If the lamp does not light up after turning on the ignition. means that its functioning is disturbed or the lamp burned out.
If the warning lamp lights up while driving, stop, turn off the engine and check the condition and tension of the alternator drive V-ribbed belt. as well as the reliability of connecting wires to the generator terminals. If the indicator lamp is on and the drive belt is in good condition, you can continue driving to the nearest service company to check the charging system. To reduce battery discharge, turn off all non-essential power consumers.
Anti-lock braking system warning lamp «ABS»
The control lamp warns of a malfunction in the anti-lock braking system. The control lamp lights up for 2 s after the ignition is turned on or during engine start-up and goes out after the end of the process of automatic check of the system performance. If the control lamp does not light up after a few seconds after the ignition is turned on, does not go out, or lights up while driving, then the ABS is faulty. If the anti-lock brake system warning light comes on while driving. The vehicle's braking system functions without an anti-lock braking system. In the event of malfunctions in the anti-lock and brake systems, which are signaled by warning lamps during braking, premature blocking of the rear wheels is possible. You must immediately proceed with extreme caution to the nearest service company to eliminate the malfunction.
(Control lamp of an overheat of the engine
The control lamp lights up at inclusion of ignition and after start-up of the engine dies away. If after turning on the ignition, the lamp does not light up. means that its functioning is disturbed or the lamp burned out.
If the warning light comes on while the vehicle is moving, stop the vehicle immediately and turn off the engine, wait for it to cool down and check the coolant level in the expansion tank.
Check the condition of the fuses or radiator fan relay. If the control lamp does not go out, and the coolant level is normal and the fan fuse is good, stop driving and call for technical assistance.
Malfunction indicator lamp
The control lamp lights up when the ignition is switched on and should go out after 3 s. If the warning light comes on while the engine is running, there is a problem with the engine and a service station should be consulted immediately. If the warning lamp flashes, immediately reduce the load on the engine until the flashing disappears and. however, consult a specialist.
Preheat indicator lamp
The preheat indicator lamp comes on after the ignition is switched on and when the engine is cold. The engine can be started after turning off the control lamp. Engine preheating time increases with decreasing engine temperature.
If the engine does not start, remove the card and start again. If the engine temperature is less than 0°C on a vehicle with a manual transmission, depress the clutch pedal while starting the engine. As soon as the engine starts, release the start button immediately. After the engine starts to run steadily, slowly release the clutch pedal. If a hot engine is started, the warning light may not come on, indicating that the engine does not need to be preheated and can be started immediately.
Control lamp of malfunction of electronic management of the engine
The control lamp lights up when the ignition is switched on and should go out after 3 s. If the control lamp lights up when the engine is running, it means that there is a malfunction in the engine management system and you should immediately consult a service station. The control lamp may begin to flash slowly, which indicates a violation in the engine start blocking system.
Minimum fuel warning lamp, fuel gauge
The control lamp lights up when the ignition is switched on and should go out after starting the engine. When the warning light comes on, fill up the car as soon as possible.
The pointer works when the ignition is on. If a few liters of fuel remain in the fuel tank, the control lamp lights up.
Control lamp of indexes of turns If the control lamp of indexes of turns blinks with the double frequency, means, the lamp in one of indexes of turns has burnt out.
Pilot lamp "SERVICE"
The control lamp lights up when the ignition is switched on and should go out after 3 s. If the warning lamp comes on at the same time as the other warning lamps, the corresponding vehicle system must be checked by a specialist.
Coolant level gauge
When the car is moving under normal conditions, the arrow should always be below the top three lines of the scale. With a heavy load on the engine and high outside temperatures, it is possible. from time to time, moving the arrow to the upper area of the scale. It shouldn't be a cause for concern until then. until the warning light starts flashing. If the coolant overheating and STOP warning lights come on while driving, stop the vehicle, turn off the engine and determine the cause of the increase in coolant temperature.
Control lamp of malfunction of system of stabilization of a trajectory to the movement of the car (ESP)
The control lamp lights up when the ignition is switched on and should go out after 2 seconds. If the control lamp lights up when the vehicle is moving. it means that in the stabilization system there is a malfunction in the stabilization system of the vehicle's trajectory, while you can continue to move. but given that this feature is missing. At the earliest opportunity, a workshop should be consulted. The warning lamp also lights up if the system is switched off by the switch. located on the instrument panel to the left of the steering wheel.
Tire pressure warning light
The control lamp lights up if in the tire of one of wheels of the car pressure is less than demanded.
Speed control indicator lamp (Cruise control)
The control lamp lights up at inclusion of system of regulation of speed.
The control lamp of a low level of a liquid in a tank of a washer of glasses and headlights
If the control lamp lights up. it is necessary to add liquid to the glass and headlight washer reservoir as soon as possible. located in the engine compartment.
Airbag warning lamp
The control lamp lights up when the ignition is switched on and should go out after a few seconds. If, when the ignition is switched on, the control lamp does not» lights up or lights up constantly, it means that there is a malfunction in the security system. in this case, it is necessary to contact a service station as soon as possible.
Control lamp of blocking of start of the engine
On vehicles equipped with an engine immobilizer system, the control lamp lights up for a few seconds after the ignition is turned on, after which it turns off, indicating that the engine can be started. If the control lamp flashes or stays on, then the code is not identified or there is a malfunction in the engine immobilizer system.
The control lamp 8 may begin to flash slowly, which indicates a violation in the engine start blocking system, and you need to contact a specialist.
Safety indicator light
After turning off the ignition, the flashing of the control lamp indicates that the car is protected from unauthorized engine start.
Multifunction display
The multifunction display may show fault indicators or textual information related to the safe operation of the vehicle.