Right: To install the rear seat cushion, hold it upright and insert the guide into the appropriate hole (shown by arrow). Then lower the rear seat cushion.
1. Front seat: On the rear side of the seat on the right, unscrew one screw each from the rear trim of the seat slide.
2. Remove facing.
3. On the outside of the seat slide, remove the 2 TORX T40 bolts.
4. On the inside of the seat slide, remove the 3 TORX bolts.
5. Remove the seat and pull it out of the vehicle.
6. Before installing the seat, clean the slide of old grease and re-lubricate only the sliding surfaces with a small amount of grease.
7. Install 5 bolts and center the seats.
8. Tighten the front and then the rear bolts first.
9. Rear seat: fold the seat cushion forward until the rails in the vehicle floor can be pulled out.
10. Carefully remove the seat from the vehicle.
11. Rear seatback: Release the rear seatback lock and fold it forward.
12. Release one lever on each side to release the hinge from the fingers holding it.
13. Take out a back from the car.
Removing the head restraints
To remove the head restraint, press down on the socket of the head restraint guide (shown by arrow). This will release the lock and allow the head restraint to be removed from the seat back.
1. When installing the backrest, check if it is fixed with a stopper.
2. Push the stopper right (in the direction of travel) holder sockets.
3. Remove the head restraint from the back.
4. To replace the guide socket, insert a screwdriver under the socket and remove it.