Removing
Remove the engine top cover.
Disconnect the connector from each glow plug.
Important note! Wear safety goggles with side pads when performing the operation.
Blow out the area around the glow plugs with an air-operated spray gun to keep contaminants from entering the cylinders.
Note. If the glow plugs and preheating sticks, use a glow plug remover.
Loosen the glow plugs with a 10 mm long socket connected to a universal joint yoke or a glow plug wrench.
Use a piece of hose to turn the glow plugs completely out.
Remove the glow plugs.
Installation
Using a piece of hose, loosely screw in the glow plugs.
Torque tighten the glow plugs (15 Nm).
Connect the glow plug connectors.
Install the engine top cover.