Raise the car.
Left rear brake rigid line
Remove the rigid pipe (1) in the area of the rear suspension beam and the rigid pipe (2) in the area of the caliper.
Release the rigid line from the holder on the rear suspension beam.
Remove the rigid conduit.
Rigid right rear brake line
Remove the rigid pipe (1) in the area of the rear suspension beam and the rigid pipe (2) in the area of the caliper.
 |
 |
Release the rigid line from the holder on the rear suspension beam.
Remove the rigid pipe. Installation is carried out in the reverse order of removal.
Note: Make sure that the brake pipes are secured in the holders without being pinched or twisted. If the brake pipes are twisted, the ABS and trajectory stabilization system will not work properly.
Tighten to the specified torque:
- rigid pipeline in the area of the rear suspension beam (14 Nm);
- rigid pipeline in the support area (14 Nm).
Bleed the brake system.